UtilityOffRoad.com Reviews:

Dual Cup Holder by SinStateCycle.com

The Yamaha Rhino is nearly the perfect machine for my uses, but one thing it lacks is a cup holder.  I shopped around extensively for a functional, ergonomically friendly cup holder and none appealed to me like the cup holder available from Sin State Cycle for less than $30 shipped.

Installation was a simple as it gets, requiring only a 3/32" allan wrench, a 11/32" nut driver (or adjustable wrench), a drill-motor, and about 15 minutes from start to finish.

The kit comes with a thick and durable ABS plastic mount, two plastic cup holders, 4 screws/washers/nuts, and instructions.

Begin installation by drilling out the rivets on the OEM warning sticker.  If the rivets try to spin on you, grab the backside with a pair of pliers.

Once the rivets are drilled out, peel the warning sticker off and clean the base plastic of any shavings and debris.

Place the mount where the sticker was, and insert the provided four screws through the holes.  Hold the screws with your allan wrench, and on the backside place  flat washers and nylon lock-nuts.  Tighten the nuts with a nut driver.

Once your nuts are tight, slide in the cup holders and fill them with beer! 

I'm really pleased with the quality of this kit.  It's a perfect design, a perfect fit, and a perfect build.  I had looked at a similar model made out of aluminum but decided that the ABS plastic design was superior as it doesn't have paint to scratch or chip, and it would hurt a whole lot less if I should bang it with my knee (or worse!).  They also offer a version with a radio cut-out but since I plan to use this space for auxiliary light switches and gauges I chose the standard version.

To learn more about the Sin State Cycle Rhino Cup Holder visit the Product Link, and thanks to Sin State Cycle for supporting this site!

Sin State Cycle
1285 Baring Blvd #232
Sparks, NV 89434
Phone - 702.953.7458
http://SinStateCycle.com